I found out the driver has an output power of 10.9 to 18.2Wso testing a single 1W light was causing it to flash. I tested with all 12 and a constant light.
I was just testing on the bench to make sure I could get one light to work with the plan of testing each time I added a light in the wall but the initial test has halted that.
Maybe I should replace the driver to rule that out?
Hi - I have built a sleeper wall outside and cut out a channel to run wiring for some LED lights, 12 lights in total. The instruction sheet (see image) states the driver needs to be 350mA Constant Current and it also states each light is 1W and the driver has a max of 18.2W so I thought this was abo...
I should have mentioned there is some moisture coming in at the base of the two exposed walls. Not much compared to the door but enough to get the rubber matting wet and then it hangs around
Thanks for your reply. It is a raised door. I think you pointed me in the right direction. I noticed a reasonable size gap on one side of the cill, where it looks like rain is getting in. Should I have somehow left a gap around the inner edge of the garage to avoid the moisture transferring to the f...
Hi - Im looking for some advice. Recently put down some self levelling compound in detached garage, single skin. Before putting the SLC down I had noticed small amount of rain water coming under the personnel door but it didn't look like much but now it's come in covering half the garage. Is it plau...
