Search found 6461 matches

by stoneyboy
Sat Jun 15, 2024 8:05 am
Forum: Plumbing Forum
Topic: Inspection chamber tissue too side
Replies: 16
Views: 696

Re: Inspection chamber tissue too side

Hi pepsiandcoke, I've added a cross section of the chamber and modifications - hope this is clear. If you could find a suitable bent pipe to insert in the side pipe then that would work but your chances of finding the right size and shape are remote. You would also have to find a way of fixing it pe...
by stoneyboy
Thu Jun 13, 2024 9:57 pm
Forum: Plumbing Forum
Topic: Inspection chamber tissue too side
Replies: 16
Views: 696

Re: Inspection chamber tissue too side

Hi pepsiandcoke, Hopefully you will be able to view the image I have attached. The red outline is the area you will need to chisel to give a rough clean surface, the blue are on the section is the area you should form to add to the haunching. Use half a soil pipe or a piece of gutter to create the s...
by stoneyboy
Tue Jun 11, 2024 10:40 pm
Forum: Tiles and Tiling Forum
Topic: Grout immediately darkened after regrout
Replies: 1
Views: 22

Re: Grout immediately darkened after regrout

Hi scg1889, It certainly looks like there is water rising up into the grout lines. This could be that it is residual water under the tiles from previous usage. Suggest you mark the extent of the darker areas on strips of masking tape adjacent to the grout lines and see what happens over the course o...
by stoneyboy
Mon Jun 10, 2024 10:52 pm
Forum: Carpentry and Joinery Forum
Topic: Repurposing shed doors into garden gate
Replies: 1
Views: 18

Re: Repurposing shed doors into garden gate

Hi rosiekay,
You will need structural support for the frame sides - either a wall or fence posts, so best to cut off the sill.
Regards S
by stoneyboy
Mon Jun 10, 2024 10:46 pm
Forum: Architecture, Self Build and Design Forum
Topic: Repairing/Replacing my Pitched Ceiling
Replies: 6
Views: 48

Re: Repairing/Replacing my Pitched Ceiling

Hi diy_luke,
The kingspan should have an integral vapour barrier so seal the joins so this becomes a continuous barrier.
Regards S
by stoneyboy
Sun Jun 09, 2024 11:57 pm
Forum: Plastering and Dry Lining Forum
Topic: Help with plastering and internal wall insulation
Replies: 4
Views: 49

Re: Help with plastering and internal wall insulation

Hi girlie26, Party wall - very unlikely to be down to bad plastering or application, you have eliminated the shower room theory, it’s most likely to be the higher floor levels and no vertical DPM on your neighbours side. Get the wall below your neighbours floor level injected with silicone fluid the...
by stoneyboy
Sun Jun 09, 2024 10:39 pm
Forum: Insulation Forum
Topic: Parent's chalet bungalow - insulation plan.
Replies: 7
Views: 70

Re: Parent's chalet bungalow - insulation plan.

Hi theteaboy,
Assuming you will be fitting RWA46 this should be stiff enough to push in place but the slabs vary in stiffness so it may be a trial and error process.
Assuming the pipes are laid above the joists, take your loft insulation strips over the pipes - do not insulate under them.
Regards S
by stoneyboy
Sat Jun 08, 2024 1:01 pm
Forum: Plastering and Dry Lining Forum
Topic: Help with plastering and internal wall insulation
Replies: 4
Views: 49

Re: Help with plastering and internal wall insulation

Hi girlie26, You have my sympathy trying to sort out this problem of condensation. Unfortunately, if you have tenants who have a lifestyle like your previous tenant, you will always have condensation problems. Ventilation is one solution but generally tenants don't like it and will make moves to sea...
by stoneyboy
Sat Jun 08, 2024 11:51 am
Forum: Architecture, Self Build and Design Forum
Topic: Repairing/Replacing my Pitched Ceiling
Replies: 6
Views: 48

Re: Repairing/Replacing my Pitched Ceiling

Hi diy_luke, Thanks for the reply and further information. If you have continuous soffit vents then the easiest way to provide high level vents is by fitting vent tiles into the loft area. The gap you have between the under-slaters felt and the insulation should be OK. I doubt it's worth swapping Ki...
by stoneyboy
Thu Jun 06, 2024 11:11 pm
Forum: Damp and Damp Proofing Forum
Topic: Raising damp?
Replies: 1
Views: 29

Re: Raising damp?

Hi sam1234,
Almost certainly rising damp which may have been worsened due to the rendering which has been applied outside.
Regards S
by stoneyboy
Thu Jun 06, 2024 11:08 pm
Forum: Glazing and Double Glazing Forum
Topic: water trapped in double glazing glass panel
Replies: 1
Views: 41

Re: water trapped in double glazing glass panel

Hi ljpc,
It looks like you have timber windows so open the window and carefully drill upwards and through the glazing gasket. Be very careful not to hit either of the glass panes.
Regards S
by stoneyboy
Thu Jun 06, 2024 11:04 pm
Forum: Architecture, Self Build and Design Forum
Topic: Repairing/Replacing my Pitched Ceiling
Replies: 6
Views: 48

Re: Repairing/Replacing my Pitched Ceiling

Hi diy_luke, Because of the location of the damp area it is more likely to be condensation, especially if it’s a north facing roof. If you are going to replace the ceiling check that the roof is ventilated - if not install some. Fit PIR insulation between the rafters leaving a ventilation gap above ...
by stoneyboy
Mon Jun 03, 2024 11:14 pm
Forum: Fillers, Sealants and Adhesives Forum
Topic: Filling large gap around window frame
Replies: 1
Views: 31

Re: Filling large gap around window frame

Hi tonyb13,
Suggest you use expanding foam, once it’s set trim it back and plaster over it.
Regards S
by stoneyboy
Mon Jun 03, 2024 11:11 pm
Forum: Concreting, Drives, Paths and Patios Forum
Topic: Can you concrete over a hardcore and screed base?
Replies: 1
Views: 35

Re: Can you concrete over a hardcore and screed base?

Hi lgc369,
You’ll be fine provided the thickness is 75mm or more. 50mm is too thin for “poured” concrete.
Regards S
by stoneyboy
Mon Jun 03, 2024 11:09 pm
Forum: Brickwork and Blockwork Forum
Topic: Using a long SDS Plus chisel
Replies: 1
Views: 30

Re: Using a long SDS Plus chisel

Hi letzdiy,
You should be fine with the long chisel but depending on the thickness of the concrete breaking it up may be painfully slow. You may do better with a sledge hammer.
Regards S
It is currently Sat Jun 15, 2024 12:30 pm