Search found 6523 matches

by stoneyboy
Fri Dec 12, 2008 10:19 pm
Forum: Masonry Forum
Topic: rendering in winter months
Replies: 6
Views: 25040

dan007,
Do use some form of frost proofer in your mix and try not to carry out the rendering when frost is forecast. Frost can remain deep in your bags of bulk sand for days - check for lumps of frozen sand or you will be re-doing the rendering.
end
by stoneyboy
Fri Dec 12, 2008 10:08 pm
Forum: Central Heating and Air conditioning and Ventilation Forum
Topic: Hot Water venting into the Expansion Tank
Replies: 2
Views: 10540

slicedbread, I cannot recall ever coming across a central heating expansion pipe in anything other that 15mm. Your expansion pipe should be an inverted U and I would suggest you try raising the height of the top of the U so that the system can operated at a higher pressure without water being pumped...
by stoneyboy
Fri Dec 12, 2008 9:57 pm
Forum: Plumbing Forum
Topic: Fitting a stone shower tray
Replies: 6
Views: 4169

jimcars,
we need more information - is the existing floor concrete, wood, chipboard or something else?
end
by stoneyboy
Fri Dec 12, 2008 9:54 pm
Forum: Plastering and Dry Lining Forum
Topic: PLASTERBOARD ONTO EXTERNAL WALL
Replies: 2
Views: 4510

McLean, You could use a dry lining adhesive but I would strongly recommend you use plasterboard with the insulation already bonded to it. If you are lining solid external walls then you are very likely to get problems with condensation forming behind the plasterboard. Even if the walls are cavity wa...
by stoneyboy
Fri Dec 12, 2008 4:13 pm
Forum: Appliances in the Home Forum
Topic: honeywell V4044 motorised valve
Replies: 3
Views: 6085

Alistair, I asume you have eliminated problems with your thermostat and CH controller. If you can move the manual operator it is unlikely that the problem is with the plumbing side of the valve. If the valve is relatively new you can fit a replacement head without draining down the system. Make sure...
by stoneyboy
Fri Dec 12, 2008 3:59 pm
Forum: Central Heating and Air conditioning and Ventilation Forum
Topic: Multi fuel stove install question
Replies: 2
Views: 3091

big-al,
Provides the chimney liner is sound there is no need to line the chimney. Don't forget to provide access to sweep the chimney and a cowl on top to limit the ingress of rainwater.
end
by stoneyboy
Fri Dec 12, 2008 3:56 pm
Forum: Glazing and Double Glazing Forum
Topic: Double Glazed Door - not sealing correctly
Replies: 3
Views: 7542

dawks,
If its a timber door and frame you need to remove the lock plate, recut the recess and move the plate nearer the sealing strip. If its and aluminium or upvc door there is generally enough slack in the lock plate to make the adjustment - undo the screws and move it.
end
by stoneyboy
Fri Dec 12, 2008 3:48 pm
Forum: Damp and Damp Proofing Forum
Topic: Loft condensation
Replies: 5
Views: 11139

armitageshanks, A temporary solution would be to put a de-humidifier in the loft, preferably one with a permenant drain. A permanent solution is to ventilated the loft area with eaves vents and tile vents or a combination of both depending on your roof configuration. It would be wise to fully lag yo...
by stoneyboy
Fri Dec 12, 2008 12:22 pm
Forum: Central Heating and Air conditioning and Ventilation Forum
Topic: Is an air release valve a pressure release valve?
Replies: 6
Views: 4372

The only problem which may occur is that the water in the pipes in the area of the expansion tank freeze and then there is no safety device for expansion. Because the woodchip boiler does not have any inherent means of instant shutdown in an over-temperature situation a pressure relief valve should ...
by stoneyboy
Fri Dec 12, 2008 12:16 pm
Forum: Plumbing Forum
Topic: Gravity fed shower has low pressure how can I increase it?
Replies: 4
Views: 26667

Leo,
You could try replacing the shower valve and head with one designed for low pressure, you need something which is claimed to work at 0.1bar or thereabouts.
end
by stoneyboy
Thu Dec 11, 2008 4:47 pm
Forum: Building Regulations and Planning Permission Forum
Topic: Neighbour's works has triggered Building Regs on my flat
Replies: 4
Views: 4984

samiad, My understanding of the BRegs is that anything over 2 storeys must have a fire protected escape route to the ground floor. I assume the 3 flats (without the loft conversion) have been in existence for many years - all the flats should already have fire doors fitted on the entrance to the com...
by stoneyboy
Thu Dec 11, 2008 4:22 pm
Forum: Brickwork and Blockwork Forum
Topic: ctp Pointing Gun
Replies: 3
Views: 3635

macw,
It's a regular problem with these guns, you need to buy some good quality building sand (even fine grains), cement and some hydraulic lime. All these components need to be fresh (so they are free from any lumps) aim for a 6:1:1 mix but you may need to add more lime to make the mix useable.
end
by stoneyboy
Thu Dec 11, 2008 4:07 pm
Forum: Central Heating and Air conditioning and Ventilation Forum
Topic: Can I burn wood in chimney flue?
Replies: 4
Views: 3123

Roclive, If you wished to comply with current BRegs the flue liner would need to be 200mm diameter for an open fire. If you are going to burn wood the fire will need a lot more air therefore a larger flue. Assuming the lining material is SS I suggest you try burning wood and if the flue is not big e...
by stoneyboy
Thu Dec 11, 2008 1:00 pm
Forum: Roofing Repair and Construction Forum
Topic: Load Bearing Wall ? Supporting the Ceiling Joist of Truss
Replies: 2
Views: 4286

scoup,
Do the bracing rafters of the trusses come down to meet above the wall you are intending to remove. If yes you need to get a structural engineer to pronounce. It may be worth doing this anyway.
end
by stoneyboy
Thu Dec 11, 2008 12:55 pm
Forum: Plumbing Forum
Topic: Fitting shower door
Replies: 1
Views: 2338

marked,
If you are lucky you may be able to find a shower door with frame which will fit the opening. These generally have adjustable sides to fit a range of openings.
end
It is currently Mon Oct 07, 2024 9:30 pm