Page 1 of 1
PVA applied to wall before tiling!! HELP
Posted: Sat May 10, 2008 10:48 pm
by ianb
PVA has been applied to walls which I wish to tile in a 3:1 ratio, Any experienced advice on what/ if anything can be coated over this to enable me to tile the walls securely?
Thank you.
Posted: Mon May 19, 2008 9:36 am
by rosebery
You can't - get as much off as possible preferably all although that will be almost impossible. Warm water, a scrubbing brush and plenty of elbow grease.
What's the substrate?
Cheers
Posted: Fri Nov 28, 2008 8:45 pm
by mdpmspitfire
you can re-pva over existing but dont allow to dry fully before fitting tiles
Posted: Tue Dec 02, 2008 1:14 am
by chris_on_tour2002
where are the tiles? if in the kitchen then i'd be inclined to leave it and just tile.
if shower/bath then you definitely want to remove. or you could reskim the wall - apply pva and plaster when tacky. then use a latex primer once the plaster had dried.
Posted: Mon Jan 26, 2009 9:42 am
by TheDoctor5
Last year 64% of the questions asked in our forum were answered within our DIY project pages at
www.diydoctor.org.uk/projects.htm The project pages are now separated alphabetically and your answers are accompanied by diagrams and the ability to see, and buy, the tools and/or required to complete your project. Use our search box to look for your answer and save a great deal of time and money!