DIY Doctor UK DIY Forums

Hi, looking for a little help / advice.

I am planing to build a built in wardrobe with sliding doors from scratch. Currently the room in question is roughly square, one end of the wardrobe will be against an existing blockwork wall, however the wardrobe will not be wall to wall so the other end will have to have some kind of end panel built.

Most of the stuff I am fine wth, however the thing that gets me is the general carcassing, the guts of the unit. All I intend to do is have two horozontal clothes rails inside, so it will be floor to ceiling height, however this is quite a bit of weight that it will carry which makes me think about the fixing to the new end panel that I will create. My question would be, does anyone have a general set of plans or rough guide / materials list for this that I could freely adapt? I mean im not sure if I should be using just 15mm MDF on the indide of the carcassing then another sheet of MDF on the outer (So MDF is sandwiching the carcassing) or plasterboard all over.

Thanks in advance.

I would think 6mm M.D.F. would be ok to cover the framework and i would use 2x2 for the frame,bit of overkill maybe.

Suppose I could strategically place some of the frame work so I could fix the clothes rails into it therefore getting a decent fixing point as 6mm seems a little thin. Thanks for the reply!

Sorry if i was a bit unclear with my reply,i was only saying 6mm could be used to cover the framework,not be used to support a hanging rail.

Thats ok, your help and reponse is appreciated.

Hi,
I've just joined DIY Doctor and seen your post. I have just done exactly what you want to do. I can let you have my plans + photo's if you haven't already built your wardrobe.

try spaceslide they had an interior system that does not need cutting from melamine and was really easy to fit

Hi,
I'm thinking of constructing some wardrobes in the bedroom. I am hoping to build an 'L' shape structure. Have you got any advice on materials, tips etc.
Much appreciated