Page 1 of 1
worchester bosch room stat problem
Posted: Thu Oct 29, 2009 5:56 pm
by angelpie
help....., my 4ys old 30cdi keeps losing its transmitter signal, the colon on the reciever flashes and i have to press the ok button to reset the signal. i have rang tech support and they weren't the helpfullest, man suggested to put fresh batterys in which i have done today, and then if not solve the problem to buy new roomstat..is this the case or should i try something else.. many thanks.............
Posted: Fri Oct 30, 2009 4:54 pm
by sparx
Hi, try moving it closer to boiler in case something is interfering with the signal.
Check for any new electronic devices between the boiler & 'stat eg PC, play station, cordless telephone base set etc.
The signal from 'stat is VERY low power and it doesn't take much to 'kill' it.
regards Sparx
Posted: Fri Oct 30, 2009 6:10 pm
by angelpie
thanks for the speedy reply sparx........ i'm going to try that. if that fails is it fair to say that the room stat is faulty??
Thanks again angelpie
Posted: Sun Nov 01, 2009 1:24 pm
by sparx
Hi again,
before doing anything drastic if it is a worcester thermostat there is a forum i found by entering Bosch Worcester 30 CDi in google and found 13 bosch engineers on line for questions, might be worth a try.
Normally such things either work or not so assuming good new battery fitted and moving it closer makes no difference must assume faulty.
Not cheap to buy but very easy to DIY replace. receiver slots in with just a low voltage 4 pin plug on short ribbon cable.
regards Sparx