Page 1 of 1
iNDIRECT BOILER
Posted: Wed Nov 04, 2009 4:38 pm
by wrcarr
hOW DO I IDENTIFY AN INDIRECT BOILER WITH A SINGLE FEED?
Posted: Wed Nov 04, 2009 6:01 pm
by rosebery
Look at the arrangement of tanks in loft and how the HW cylinder is piped.
Cheers
Posted: Wed Nov 04, 2009 7:53 pm
by DEEARR2
Are you refering to the hot water storage vessel (copper cylinder). If you are then an indirect unit has one pipe entering at low level and one pipe leaving from top dead centre An indirect cylinder has the same two pipes but a further two entries half way up.
Posted: Sat Nov 07, 2009 2:32 pm
by rosebery
"DEEARR2" said:
"Are you refering to the hot water storage vessel (copper cylinder). If you are then an indirect unit has one pipe entering at low level and one pipe leaving from top dead centre An indirect cylinder has the same two pipes but a further two entries half way up."
The cynic in me says that the OP is looking for help with his homework.
Cheers