DIY Doctor UK DIY Forums

Hi All, I've got a uPVC Window which does not close evenly on both sides. When its closed fully the hinge side does not press against the rubber seal so the gap between the sash and the frame is about twice what it is on the latch side. Its a simple hinged window, no fancy moveable hinges or anything like that.

From what I can see there are two triangular plastic pieces attached to the sash top and bottom and they engage with two other plastic pieces attached to the frame which have corresponding cut-outs. There doesn't appear to be any adjustment, nor does there appear to be a way of replacing these pieces without replacing the complete hinges.

Is this right? or have I missed something? :?

No you're not missing anything. Those grey trianglular bits of plastic are meant to engage into the other two bits on the hinge. You will notice that they are not engaging and thus not sealing the casement. Two new hinges are required because you cannot dismantle the old ones. For about a tenner its not worth even considering.

Thanks for the advice. New hinges it is then.