Electro heat Amptec 900 strange behaviour
Posted: Sun Jun 17, 2018 9:46 am
Hi All.
Hope someone can help :)
I have a Electroheat Amptec 900 electric boiler, pressurised and to a Titan cylinder.
It’s acting strange.
The boiler won’t fire up unless I ‘prime’ it with the immersion heater for say 30mins to an hour?
From cold it calls for ages then the alarm comes on. But if i use the immersion heater for an hour then fire it up it will work ?
Any ideas ??
Secondly the pump runs for about 2 hours after the boiler timer turns off. It used to run between 5 & 30 minutes ?
Are the problems connected ?
Vague I know, just hoping for some tips.
Hope someone can help :)
I have a Electroheat Amptec 900 electric boiler, pressurised and to a Titan cylinder.
It’s acting strange.
The boiler won’t fire up unless I ‘prime’ it with the immersion heater for say 30mins to an hour?
From cold it calls for ages then the alarm comes on. But if i use the immersion heater for an hour then fire it up it will work ?
Any ideas ??
Secondly the pump runs for about 2 hours after the boiler timer turns off. It used to run between 5 & 30 minutes ?
Are the problems connected ?
Vague I know, just hoping for some tips.