Page 1 of 1
F30E - No HW when CH in on
Posted: Wed Jan 02, 2008 6:17 pm
by vipin
Saunier Duval F30e combi boiler: HW is okay on its own, CH is okay. But when CH is on and HW is turned on, the boiler tries for a few seconds and then shuts down with F9 in display and red light flashing. Pressure is bet 1-1.2bar. Have replaced water pressure sensor; gas valve stepper motor and 3way valve head piston(pin) working okay. Any help out there will be highly appreciated. Thanks.
Posted: Thu Jan 03, 2008 9:42 pm
by humperdink
maybe p.c.b.
Posted: Sat Jan 05, 2008 3:33 pm
by vipin
Thank you, but I suspect something mechanical, and am going to remove and inspect the 3way valve as soon as weather permits (the boiler is located in an outside toilet!). Will let u know when I find something.
Thanks again.
Posted: Sat Jan 05, 2008 5:37 pm
by roger196
Get hold of the manufactureres instructions ( their website will give a phone number). These should tell you what fault F9 is.
Posted: Tue Jan 08, 2008 5:54 pm
by vipin
The Manual states that F9 indicates:
1. Water pressure sensor - but I have changed that with no results.
2. Stepper motor - I have checked this according to their instructions, and it works. I also checked the motorised 3way valve head, and it works.
3. Overheat stat (manual reset) - but the stat does not trip!
That is all the help they can give, hence my cry for help.
Posted: Sat Jan 01, 2011 7:29 pm
by hfz3
Hi Vipin
Did U fix the problem?
Regards
Curt
Posted: Sun Jan 09, 2011 11:57 pm
by vipin
[quote="hfz3"]Hi Vipin
Did U fix the problem?
Regards
Curt[/quote]
NO. I just haven't had the time to tackle it. Thought it might be wiser to save the money on a new PCB and get a new combi. But it is still working as before. Any suggestions, Curt?
Thanks
Vipin.