Page 1 of 1
Immersion heater gasket
Posted: Wed Mar 03, 2021 1:50 pm
by eastcoast
When installing a new Immersion heater to a cylinder,
1) Should jointing compound be used with the fibre gasket?
2) Should PTFE tape be used on the thread?
Re: Immersion heater gasket
Posted: Thu Mar 04, 2021 9:41 pm
by stoneyboy
Hi eastcoast
1 - no 2 - no apply Vaseline to the threads in case you have to remove the heater at some time in the future. Regards S
Re: Immersion heater gasket
Posted: Fri Mar 05, 2021 10:23 am
by eastcoast
[quote="stoneyboy"]Hi eastcoast
1 - no 2 - no apply Vaseline to the threads in case you have to remove the heater at some time in the future. Regards S[/quote]
Thank-you stoneboy. I did not have any Vaseline so I used copper slip. Regards.