DIY Doctor UK DIY Forums

Hi, is it possible for me to fix a temporary extension lead to my shed via a socket in my kitchen and fix a cpu unit on to it then run off the relevant sized wiring to power lighting and a few sockets ( only until I get a sparky to sort out a more permanent fixture the cpu will remain fixed to the internal shed wall aswell as the wiring for lighting and power ready for a more permanent fixture in the near future )
the cable I have in mind is a heavy duty external extension cable used in building sites to power heavy machinery.
specs on the plug states
16A-4h
100-130V~
50-60Hz
2P+E
plus will I still need to notify relevant parties even though it will be used as a temporary solution and not a permanent fixture , the cable will be travelling along a wall from kitchen to shed
cheers NOODLES

100-130volts domestic volatage is 230v this type of cable is for site application using 110v set up.
I'd say if you intended to do this using a cable that was rated at domestic voltage to fixed installation within garage.
Answer
No!

You could get away with it on portable equipment providing extension lead had RCD protection.
KB

[quote="kbrownie"]100-130volts domestic volatage is 230v this type of cable is for site application using 110v set up.
I'd say if you intended to do this using a cable that was rated at domestic voltage to fixed installation within garage.
Answer
No!

You could get away with it on portable equipment providing extension lead had RCD protection.
KB[/quote]

Thanks for the quick reply,
what type of cable should I use instead ?

[quote="NOODLES"]

Thanks for the quick reply,
what type of cable should I use instead ?[/quote]

I would not recommend a temp set up for a fixed installation, I'd recommend getting your electrician on the job and have the job done safely and correctly. Before you get to used to the temporary fix and a potential hazardous situation, escalates to something more dangerous or fatal.
KB