DIY Doctor UK DIY Forums

I removed an old light fitting in my kitchen and replaced it with a 3 spotlight bar fitting after wiring it according to the instructions supplied only one spotlight ( the middle of the 3 ) works any suggestions ?

2 of the internal connections are not bproperly connected.

Are all the terminals tight and correct on the other lamps are the lamps(bulbs :? ) okay

Spotlights I have installed in the past have sepearate flexes for each spot which are joined in a connector strip. The supply then comes into this strip from the other side. If only one light is working but all three flexes are in the strip it may be faulty, in which case return it to the shop you bought it from.

Not sure if the problem is that there is only one wire from the ceiling

I'm no expert on the different forms of wiring for lighting circuits, however if one of the lights is on then as long as all the wiring in the light fitting is correct you shouldn't need any more cables from the ceiling.

Power is being supplied down one cable and it should be sufficient to supply more than 3 spots.

[quote="jazp1970"]I removed an old light fitting in my kitchen and replaced it with a 3 spotlight bar fitting after wiring it according to the instructions supplied only one spotlight ( the middle of the 3 ) works any suggestions ?[/quote]

hi im an electrician.....MW ELECTRICAL....CARLISLE..

assuming that one of the lights are working...check you havent pulled any wiring away from the light fitting itself......accidentally occuring whilst you have wired it up......it happens to me, and ive been a sparky since 1982.

asuming everything is fine and there are no loose wires from the fitting...
check you bulbs are ok...check that they are fitted securely....
trust me.....it will be one or the other.....

let me no how you get on.

Mark ..