DIY Doctor UK DIY Forums

Hi all, newbie post.

I have a dual gang switch with connections as below:

Switch 1
COM - Brown connected to switch 2 COM also 2 more Brown wires.
L1 - Brown wire.

Switch 2
COM - feed from switch 1 COM
L1 - Brown Wire

All blues are connected together - switch is plastic so all earths connected together.

I have changed the faceplate and can't now get switch one to turn on the relevant light - could someone steer me in the right direction please.

DIYMonkey

You may have mixed up the brown wires, or done up the screw on the insulation of one core. If sw. 2 turned on does sw 1 then work? If so swap wires on sw 2 (com-L1) leave link in comms.
Presume you have 3 blues in term block?
Regards SPARX