Page 1 of 1

Mains Voltage Downlighters

Posted: Wed Jul 04, 2007 10:03 am
by misterg
Hi

I have three mains voltage downlighters to hook up to a single switch.

What's the best way of doing this? Should I treat them as normal lights?

Cheers

MisterG

Re: Mains Voltage Downlighters

Posted: Wed Jul 04, 2007 1:48 pm
by BLAKEY1963
[quote="misterg"]Hi

I have three mains voltage downlighters to hook up to a single switch.

What's the best way of doing this? Should I treat them as normal lights?

Cheers

MisterG[/quote]

MISTERG
PRESUME THESE R 4 KITCHEN OR BATHROOM ?
GET YOUR REGISTERED SPARKY TO DO.
AS PART P COULD APPLY.

BLAKEY1963

Posted: Wed Jul 04, 2007 3:21 pm
by misterg
Blakey

It's for the inside of a built in wardrobe in a bedroom.

Regards

MisterG

Posted: Wed Jul 04, 2007 9:46 pm
by sparx
Hi misterg, take supply from room pendant, if wanted on with existing lights then connect to same terms as existing flex(unlikely),or if you want to put in local sw then connect to N + loop-in Lives at pendant & run to new sw. position, also loop from (new) light to light & take last cable to new sw. also.
At new sw. loop both BLUES (neutrals ) in term. block in sw. box, put live in to C in sw. & sw.Line out to lights in L1, earths together in term block,
regards SPARX

Posted: Thu Jul 05, 2007 1:19 am
by misterg
Thanks Sparx.

I'll give it a go.

Cheers

G