DIY Doctor UK DIY Forums

Hi,
I have a query.I am to fit a provision point for underfloor heating in a new build and am a little uncertain if I should run it off an RCD circuit-being in the bathroom environment.

I will be mounting the thermostat outside the bathroom as to avoid mositure getting into the unit.The main supply for the underfloor heating is my main concern as I was going to take it off the nearest socket in the bedroom and fit it on a 13A fused spur (changing the fuse to the appropriate size of course). Both spur and thermostat will be outside the bathroom area.

I have read that the sensor has to be run in conduit.Is this from the thermostat to the electric matting?This house is a timber build with plasterboard finish and the flooring in the bathroom will be screeded and tiled.

Please could you guide me in the correct way as to not make a vital mistake.

Regards and thank you for your time and advice,

Hi, I would use an RCD fused spur, the stat is usualy a capiliary tube which although not electrical is very easily damaged, & some types are a thermocouple also fairly fragile so If poss i would put in tube,
regards
SPARX

Thanks for the advice.I'll make sure i fit it as follows.
Regards,