Wiring in a lighting sensor to existing outside lights. Ask questions and find answers to many subjects relating to electrics and electrical work

[Gaspin]

I have recently installed 2 outside lights which are about 6ft apart and on the same circuit and I would now like to wire in a sensor, so that the lights will activate for a short while when someone approaches them. These lights are on an outbuilding and I do not need to incorporate a timing device or dusk to dawn facilitly but only need the existing manual on/off mechanism. I would like advice on what type of unit to buy, taking into account the above, and how to install it into the existing circuitory.

Thanks.

[BLAKEY1963]

[quote="Gaspin"]I have recently installed 2 outside lights which are about 6ft apart and on the same circuit and I would now like to wire in a sensor, so that the lights will activate for a short while when someone approaches them. These lights are on an outbuilding and I do not need to incorporate a timing device or dusk to dawn facilitly but only need the existing manual on/off mechanism. I would like advice on what type of unit to buy, taking into account the above, and how to install it into the existing circuitory.

Thanks.[/quote]


GASPIN
RESPECT U HAVE HAD A GO BUT THIS IS IS NOTIFIABLE WORK
AND YOUR PART P SPARK SHOULD ADVISE.
READ DOC S PART P ADVICE SECTION.

BLAKEY1963