Page 1 of 1
CROSS BONDING
Posted: Tue Nov 20, 2007 8:20 pm
by MICK101
HI JUST FITTED A ELECTRIC SHOWER.FOR CROSS BONDING DO I NEED TO RUN THE 4 MM EARTH CABLE BACK TO THE CONSUMER UNIT EARTHING TERMINAL.
Posted: Wed Nov 21, 2007 11:02 pm
by Kristof
You don't have to, but make sure your supplementary bonding is continuous, radiator, buthtub, copper pipes, Electric shaver socket, any exposed conductive parts have to be bonded
Posted: Thu Nov 22, 2007 7:20 am
by MICK101
CHEERS KRISTOF SO DO I NEED TO FINISH OFF BY CONNECTING THE 4 MM EARTH TO THE EARTH TERMINAL ON THE 45 AMP SWITCH ?
Posted: Thu Nov 22, 2007 7:30 am
by thedoctor
See our projects section and look at the project called earth bonding.
Posted: Thu Nov 22, 2007 11:00 am
by kbrownie
Hi MICK101,
Becasuse electrical shower should be on a circiut independant to it's self, earth does need to be terminate back the fuse/mcb at CU.
Regards
KB
Posted: Fri Nov 23, 2007 9:43 am
by Kristof
MICK101,
you have to run a short lengh of 4mm cable from copper pipe (using earth clamps) suppling water to electric shower and terminate at the el. shower's earth terminal. Keep the bonding continuous, from there (copper pipe) to buthtub, radiator, any exposed conductive parts