Page 1 of 1

Cutting Fence Posts to Size When Already Installed

Posted: Mon Mar 05, 2018 4:19 pm
by truebluedom
Hi Guys,

I have recently installed a load of picket fences along a raised wall, the ground wasn’t perfect due to the pre-existing wall so the fence post have been installed and concreted in at different heights.

Fence is on and level, now I just want to level off the fence posts (they are 3x3’s). I plan to use a reciprocating or hand saw, this tool looks ideal but I’m not spending over £100 on it - https://www.amazon.co.uk/ReciProMate-Re ... B00KSTW0Z6

Anyone got another method or product I can use to ensure I get a straight cut?

Thanks

Dom

Re: Cutting Fence Posts to Size When Already Installed

Posted: Sat Mar 10, 2018 1:38 pm
by Skid Sprocket
The tool you refer to looks like the guide only you will also need the reciprocating saw. How many posts have you to cut? if it only up to ten or so i would use a handsaw. Mark a line about half way between the top of the top rail and the top of the pickets at a slight angle away from the pickets (to allow rain water to run off) and invest in a new handsaw, under £10, and the 3 x 3 should be easily cut off. If you have dozens to cut then hiring a power saw for a one off job may be best the option.

Re: Cutting Fence Posts to Size When Already Installed

Posted: Sat Mar 10, 2018 8:44 pm
by truebluedom
Skid Sprocket wrote:The tool you refer to looks like the guide only you will also need the reciprocating saw. How many posts have you to cut? if it only up to ten or so i would use a handsaw. Mark a line about half way between the top of the top rail and the top of the pickets at a slight angle away from the pickets (to allow rain water to run off) and invest in a new handsaw, under £10, and the 3 x 3 should be easily cut off. If you have dozens to cut then hiring a power saw for a one off job may be best the option.


Thanks, I think only 4 or 5 will need cutting