DIY Doctor UK DIY Forums

Hi, planning to lay natural slate tiles onto a concrete base floor with electrical underfloor heating.

Whats the best way to set the heating cable in ? I previously just bedded it into the adhesive and simply laid tiles directly on with no issue, apart from it being awkward and messy ! Is this an ok method ?

The instructions for the heating cable tell you to set it into morter, would you need to add something to this to give it some flex, or does this only apply to the adhesive ? Does it matter if the morter is just thick enough to cover the heating cables ?

I really want to keep the height of the floor to a minimum, so it matches up with other floorings in different rooms.

Advice much appreciated....

chazzyboy,
Bed the cable in the adhesive as you have done before. If you try bedding in a concrete layer and then tiling, the concrete layer is unlikely to remain bonded to the existing concrete floor.
end

Stoneboy, thanks for the reply. It does seem the easiest way, and keeps the height to a minimum, cheers.

Last year 64% of the questions asked in our forum were answered within our DIY project pages at www.diydoctor.org.uk/projects.htm The project pages are now separated alphabetically and your answers are accompanied by diagrams and the ability to see, and buy, the tools and/or required to complete your project. Use our search box to look for your answer and save a great deal of time and money!