DIY Doctor UK DIY Forums

I bought a kitchen sink mixer tap on the internet (silly, I know!) that I suspect may be a high pressure tap. Is there a simple cost effective way to make it operate adequately on a low pressure system? Thanks

in short, no, unfortunately. the cold side should be fine - your kitchen cold tap must be mains fed in accordance with the regs as it's your drinking water. therefore will work fine with that tap. however the only way to get the hot side to work properly will be to install a pump.

it might be possible to switch the tap's innards for low pressure but i doubt it. most expedient option is to change the tap. see if they do a low pressure version of the same.

good morning
probarly some form of inline pump search the internet or return the tap and get a low pressure one
bob

[quote="chris_on_tour2002"]in short, no, unfortunately. the cold side should be fine - your kitchen cold tap must be mains fed in accordance with the regs as it's your drinking water. therefore will work fine with that tap. however the only way to get the hot side to work properly will be to install a pump.

it might be possible to switch the tap's innards for low pressure but i doubt it. most expedient option is to change the tap. see if they do a low pressure version of the same.[/quote]

Thanks for your help, one more question, how is the hot water likely to perform if I fit it as is.

there is absolutely nothing to stop you trying. the worst that will happen is that there will be no hot water coming through the tap.

fit it and see, it's really the only way you will know. it depends on how good your hot water pressure is presently - at best it will be ok, at worst you will get only a trickle or possibly no hot water at all. worth a try before exploring all other options.

Just read this problem and I have the same low, low pressure - after having what is supposed to be for a low pressure system. Could you suggest what kind of pressure pump would be required for the hot water side?
Thanks.
mraich