Page 1 of 1

Baxi Solo WM 50/4RS

Posted: Wed Dec 31, 2008 12:03 am
by bunts
Pilot lites but goes out when turn knob to next position. Thermostat trip switch has been reset but still does not resolve the problem. For information this started after I removed and replaced two radiators to clean them through and I completely drained the whole system to do this. Before trying to restart my boiler, the heating system was refilled and air bleeded from all radiators.

Posted: Thu Jan 01, 2009 7:01 am
by Steve the gas
Hi Bunts,

You seem to be describing a permanent pilot that will not stay lit?

If so , the thermocouple has failed,approx £6 + fitting


Hth

Pilot not staying on

Posted: Sat Jan 03, 2009 3:07 pm
by bunts
Thanks for advice. Thermocouple changed but still not working. Engineer called and replaced the boiler thermostat which did the trick.

Posted: Thu Jan 29, 2009 12:34 pm
by TheDoctor5
If you type the key words of your question into our search box to the left of the site you may find the answer is already posted or is in the DIY projects section of the website. Every post goes through a monitoring process and using the search box may speed up your answer.