Page 1 of 1
Pillar taps
Posted: Tue Jan 06, 2009 6:12 pm
by davevent1
Hi all, my bathroom hot water tap as become very slow and nearly stops it was fine before also the tap only turns one full turn for it to go on or off,what is the reason any ideas guys. thanks dave.
Posted: Wed Jan 07, 2009 6:31 pm
by stoneyboy
davevent1,
take the headwork off the tap and look for build-up of limescale or washer forced into recess.
end
Posted: Wed Jan 07, 2009 7:28 pm
by Stelf
I'm afraid you are going to have to take the tap apart and clean and lightly lubricate the internal working parts, then reassemble. Make sure you turn the water supply off first before attempting any repair, but be careful as turning off water supplies can be tricky, especially if they have not been turned off for a long time. Only a small job but it can be aggro. You should not need a new tap. If you get stuck you may be as well to hire a reputable plumber.
Best wishes
Posted: Thu Jan 29, 2009 1:23 pm
by TheDoctor5
If you type the key words of your question into our search box to the left of the site you may find the answer is already posted or is in the DIY projects section of the website. Every post goes through a monitoring process and using the search box may speed up your answer.