DIY Doctor UK DIY Forums

hi,

a thermostatic valve on one om my raduiators has sprung a leak. I removed the head and noticed the water was dripping from around the pin. I tightened the nylon nut holding the pin in place which has seemed to stop the leak.

Is this good enough or would you recommend replacing the whole thing

many thanks

p4t,
Leave well alone and see if it leaks again.
end

If you type the key words of your question into our search box to the left of the site you may find the answer is already posted or is in the DIY projects section of the website. Every post goes through a monitoring process and using the search box may speed up your answer.