Page 1 of 1
Imersion heater not working?
Posted: Wed Jan 07, 2009 1:42 pm
by susan1349
[color=violet]Please can someone help..
I thnk my water imersion tank is not working correctly as we do not have any hot water at all and have to boost the water system to get any hot water in any of the taps.
Any ideas would be very greatfully received!! :D [/color][size=12][/size]
Cheers
Posted: Thu Jan 08, 2009 6:34 am
by Steve the gas
Hi Susan,
What do you mean by 'boost' the system = need all info you can give.
Posted: Thu Jan 08, 2009 1:58 pm
by susan1349
Hi,
I have an electricsaver box on my wall beside the hot water tank and i can start and cancel it to boost the water so that it heats up quickly. This is the only way i can heat the water up.
Cheers
Posted: Thu Jan 08, 2009 8:00 pm
by chris_on_tour2002
assuming that ordinarily your hot water system runs from a boiler? you don't say in your post.
if it does run from a boiler and your rads are still working ok then it could well be the diverter valve - though there are many other possible causes.
if electric only (immersion) then most likely the element has gone.
either way you really need to call in a plumber to take a look.
Posted: Fri Jan 09, 2009 10:02 am
by susan1349
Hi,
Yes its imersion only. Thanks for your help.
Posted: Thu Jan 29, 2009 1:26 pm
by TheDoctor5
If you type the key words of your question into our search box to the left of the site you may find the answer is already posted or is in the DIY projects section of the website. Every post goes through a monitoring process and using the search box may speed up your answer.