Page 1 of 1
Kitchen mixer tap
Posted: Sat Feb 20, 2010 8:40 pm
by davejohnparkes
I am going to buy a new kitchen mixer tap which states: Minimum pressure requirement 1 BAR (not suitable for low pressure/gravity fed systems)
I have a combi-boiler, no emersion.
The combi is set at 1.9 BAR so I'm hoping this system will be okay?
Cheers.
Posted: Sun Feb 21, 2010 6:03 pm
by James1000
If you have a Combi already its very likely that you already have 1 bar or more ,i doubt it would operate on anything less.
The 1.9 bar i assume your referring to is what the needle on the gauge is showing on the front of your boiler this gauge shows the water pressure in your heating system ,which should be on around 1 bar when cold then it will rise up as the water in the system expands as long as its not in the red its OK.
Tap - new
Posted: Mon Feb 22, 2010 1:29 pm
by davejohnparkes
Yes I was referring to the guage on the front of boiler. Many thanks for your reply James.
Posted: Mon Feb 22, 2010 2:12 pm
by chris_on_tour2002
if you had less that 1 bar i think you'd know about it - the pressure would be appalling. i have 3 bar where i live (well, at 3am anyway! peak times it's closer to 2 bar) and it's only just about tolerable.