DIY Doctor UK DIY Forums

Hello,

I am trying to replace a cistern coupling washer, however I am confused by the pipe which feeds fresh water into the flush mechanism; specifically the plastic connector in the picture below: http://www.flickr.com/photos/66661215@N05/6070557128/

Anyone have any ideas what this is and whether I screw it off, pull it off?

Thanks in advance,

Michael

@ crookesm

The fitting looks like a type of push-fit tap connector. The nut on the tail piece of the inlet valve unscrews in the normal fashion, the plastic part of the fitting will probably have some sort of release mechanism, which after being activated will allow the fitting to be pulled from the pipe.

If you want to remove the fitting completely and can't get it off, just cut through the copper pipe under the fitting with a junior hacksaw, then use an alternative fitting to make good again afterward, such as a 15mm-1/2" flexi tap connector or a 15mm-1/2" Speedfit tap connector.

Ah yes! Thanks very much for your help!