Tightening 28mm x 1" Elbow Alignment
Posted: Thu Mar 05, 2020 1:43 pm
Hi.
I'm tightening up a 28mm x 1" elbow, into a fixed point, and the 28mm pipe end is always firming up maybe 30 degrees to soon.
I've tried altering the amount of PTFE tape, but to no avail.
Is there any handy way of getting this elbow to firm up in the right place?
Thanks
I'm tightening up a 28mm x 1" elbow, into a fixed point, and the 28mm pipe end is always firming up maybe 30 degrees to soon.
I've tried altering the amount of PTFE tape, but to no avail.
Is there any handy way of getting this elbow to firm up in the right place?
Thanks