Page 1 of 1

Showering Salamander universal pump installation

Posted: Wed Dec 30, 2020 7:57 pm
by Bubble
Hi all Just signed up ! My first post.I am about to install a Salamander universal pump to a gravity system that will supply a shower & also H/C to a bath & basin.I intend to tee in to the cold supply from Cw tank & tee in to the hot supply from the cylinder! My question is should I got non return valves above the tees to stop pumping back to tank or cylinder ?or will this cause a bent problem on the hot supply! As the pipework at this point supplies the house ! Far too much work to install dedicated supplies. Look forward to comments many thanks in advance Bubble

Re: Showering Salamander universal pump installation

Posted: Thu Dec 31, 2020 10:21 pm
by stoneyboy
Hi bubble.
Since you are tank fed for both hot and cold there is no need for NRVs
Regards S

Re: Showering Salamander universal pump installation

Posted: Fri Jan 01, 2021 11:01 am
by Bubble
Many thanks stoneyboy. Happy New Year !