DIY Doctor UK DIY Forums

Hi I have a freestanding bath tap, and purchased 2 x 900mm flexi tails, however the M12 threads are too small for the bore of the thread inside the tap head,everyone seems to sell M10 or M12, is there a larger alternative or an adapter, I'm going mad with this ! any help/ advice greatly appreciated. Thanks, Dennis

Hi diamondden,
Assuming you are referring to flexible tap connectors you need to swap the 1/2” BSP ones you already have for 3/4” BSP ones. Try to find ones that have the right fitting on the other end for the supply pipes usually 15 or 22mm.
Regards S