adhesive not setting under quarry tiles in bathroom
Advice and information on tiling and fixing tiles to a variety of surfaces

3 posts   •   Page 1 of 1
fiona
Labourer
Labourer
Posts: 1
Joined: Tue May 06, 2008 8:33 am

adhesive not setting under quarry tiles in bathroom

by fiona » Tue May 06, 2008 8:59 am

hello my boyfriend is redoing our bathroom & is putting down quarry tiles on the floor,5 of these tiles the adhesive didn't set so he had to buy some more adhesive to redo them.2 of these tiles will still not set.They are next to the bath.It's an old house so floor isn't all level,so he has put down extra adhesive,but it has been over a week & it's still not setting underneath.we are trying putting a fan heater on them to see if that will help.The adhesive he is using is unibond tiling on concrete floors extra strong waterproof adhesive & grout.it's getting quite expensive so if any one could help that would be good.thankyou

rosebery
Project Manager
Project Manager
Posts: 2021
Joined: Wed Sep 26, 2007 9:55 pm

by rosebery » Wed May 07, 2008 6:46 pm

Oh dear. It won't set because adhesive shouldn't be used as a levelling compund, it's far too thick as a result and because it's a combined adhesive / grout concoction which as a product I (personally you understand) hate with a passion.

You are not going to like this but I'm going to recommend that you take them up and level the floor with SLC prior to tiling.

Then I'd recommend that you use a bagged adhesive like BAL (or Ardex, Granfix etc equivalents) SPF or CTF3 and a separate grout like BAL Microflex Wide Joint Grout (or again others) equivalents. Alternatively you can persist with the Unibond after levelling - it's entirely up to you BUT you MUST level first.

Cheers

chris_on_tour2002
Project Manager
Project Manager
Posts: 1024
Joined: Thu Aug 30, 2007 10:14 pm

by chris_on_tour2002 » Fri May 30, 2008 12:03 am

totally agree with rosebery - those ready mixed floor tile adhesives are a complete waste of time - especially the adhesives and grout in one.

i am guessing that you quite likely bought it from a very large diy chain where people walk around in orange overalls, or a similar chain where they walk around in green overalls with a little orange dot on the pocket. am i right?

do yourselves a big favour and go to a tile shop. buy the stuff that the professionals use. you wouldn't catch pros using that c**p, don't be fooled by the 'extra strong', its a relative term. it's only extra strong in comparison to their own other products.

3 posts   •   Page 1 of 1
It is currently Tue Nov 05, 2024 8:36 am