Hi all,
I'm looking to construct a timber-frame external wall to replace an existing part-brick wall.
Situtation: like most things in my house, a flat-roofed side extension to my house is a massive bodge (e.g. cavity wall was filled with wet sand, damp soil piled up against bricks such that dpc is 3ft below ground, etc). It is constructed from waist-high brick wall with top half made entirely of windows (2m x 7m side extension with roof entirey supported on the rotten wooden windows). The roof and floor are fine. I figure it is worth cutting losses and knock out the wall and windows (after proping up the roof) and replace with a timber frame wall with proper insulation and a sensible amount of windows (uPVC).
Could anyone steer me towards a good guide on single-story timber frame (studwork) extension building? I'm good at general DIY, but would like a guide that includes the general stuff that needs to be done right....e.g. how do you fix a timber frame down to the dpc (or is a layer of bricks needed in between), etc.
Any help and suggestions greatly appreciated.
Cheers
Kev