Page 1 of 1
FITTING A CORNER SINK, POSITION FOR WORKTOP JOINTS
Posted: Wed Jun 18, 2008 10:40 am
by powerfulpierre
CORNER SINK by Sauber, two s'steel bowls joined at right angles, laminate worktops, where do I put the worktop joint to avoid cutting most of it away? The corner is not a diagonal setup, just the normal right angle between the worktops. Any suggestions?
Posted: Wed Nov 19, 2008 7:51 am
by kayliekitchen
If you Google "bathroomandkitchenguide.com" you may find a solution
Posted: Wed Jan 28, 2009 10:32 am
by TheDoctor5
If you type the key words of your question into our search box to the left of the site you may find the answer is already posted or is in the DIY projects section of the website. Every post goes through a monitoring process and using the search box may speed up your answer.