Finding the Right Coupling Fittings for Compressor
Posted: Wed Jun 03, 2020 6:21 pm
Hello,
Really quite new to DIY in general and I've gone and bought myself a Draper DA50/207 50L 230V 2.0HP Air Compressor. Along with the purchase, I also bought a Draper 52662 7.6 m 1/4-Inch BSP Nylon Recoil Air Hose.
I also got a Dewalt DPSB2in1 Combination Nailer to use with the compressor.
Trouble is, I just can't figure out how to connect it all together. I've got as far as needing a 1/4" NPT High Flow Fitting for the gun and 3/8" (10mm) Air Hose fitting, but not sure about the couplings for the other side. Searched all over Google, but really can't figure it out.
Any advice would be much appreciated! Feeling a bit flummoxed by it all!
Really quite new to DIY in general and I've gone and bought myself a Draper DA50/207 50L 230V 2.0HP Air Compressor. Along with the purchase, I also bought a Draper 52662 7.6 m 1/4-Inch BSP Nylon Recoil Air Hose.
I also got a Dewalt DPSB2in1 Combination Nailer to use with the compressor.
Trouble is, I just can't figure out how to connect it all together. I've got as far as needing a 1/4" NPT High Flow Fitting for the gun and 3/8" (10mm) Air Hose fitting, but not sure about the couplings for the other side. Searched all over Google, but really can't figure it out.
Any advice would be much appreciated! Feeling a bit flummoxed by it all!