Hello
I bought a detached Victorian house from the 1880s. The previous owner has created on all but one side of the house terraces. They look nice, but mean that now soil is touching the outer wall above floor level. As a result of this there is now damp on some of the interior walls (but only where there are the newly created terraces), in particular where plants have been put up close to the outer wall. The surveyor is not sure whether a physical damp proof course exists. The house has a suspended timber floor. There is no basement in most of the affected areas.
The surveyor's main suggestion was to build an aco drainage around the house. Does that make sense in your opinion?
If yes, how exactly would you construct the aco drainage? 1) How close to the exterior walls of the building should it be? I was thinking that as the terraces have been newly created, there should be no structural issues exposing the outer walls and putting the aco drainage right next to it, as this would have the advantage that soil is no longer touching the wall 2) Would you put an insulation layer on the newly exposed parts of the outer brickwork? The current owner is currently applying waterproof paint, but both the surveyor and a builder I spoke to said that this would only last for a few years. The surveyor recommended asphalt or a heavy felt, but the current owner raised the issue that this would not let the wall breath. Which sort of water proofing would you recommend? 3) How exactly would you recommend to construct the aco drainage? I saw on the web, that there are pre-fabricated aco units, i.e. the actual channel/tube where the water flows plus the grid on top of it. The surveyor, however, recommended to dig a channel and clad it with concrete and then put a grid (aco) on top of it. 4) Or would it be the best solution to remove soil as deep as it is required so that the ground level next to the wall is 20cm below the inside floor level and rather than putting the aco drainage inside this channel, to dig even deeper and put the aco drainage such that the upper end of the aco drainage is 20cm below the inside floor level? 5) Would you recommend, additionally, to inject a chemical damp proof course? If yes, where should it be, just below the inside floor level? 6) Would you recommend replastering the internal wall and if so which type of plaster would you recommend, a moisture repelling one? 7) Once there is drainage via the aco - is specific rainwater splashback protection still required, like for instance a transparent silicone paint, or does this again raise issues of how the wall can breathe?
Many thanks for your help.