I have a pipe bender which is 2yrs old and had DIY not commecial use it now doesn't bend 15mm because of a gap of about 10mm between the bar on the pipe and the pressure wheel which should run along the bar to create the bend. this occured sudenly ie: last week bending pipes for kitchen and now now chance with this gap.
Confused as to what the cause is as nothing loose none of the parts can be adjusted pressure wheel turns oK.....I'm stumped.
Don't know if the 1" side is same not use it. cost around £35 can't rember exact.
Many thanks to all who reply even if it's don't buy cheap tools.