by marie48 »
Tue Nov 29, 2011 12:48 pm
Thanks welsh brickie. That's the second quote, the first was over 2 yrs ago and it was not even that bad only a very small patch and he said it was rising damp and quoted over 1k. I am going to get them to requote and question their diagnosis. The builder is also coming to check the roof next week, he is very good but very expensive. I do not know whether I have posted the report and sketch of the damp area. Here it is again to give you an idea, the report & sketch are not allowed for me to download. This is really doing my head in but am glad that you said it is not urgent, the surveyor said the same. The report scares me esp about rot. Thanks a lot for your advice.
Our initial diagnosis is based on a visual appearance of the wall surfaces,
supplemented by non-destructive testing with the Protimeter Electric Moisture Meter.
Evidence of excessive moisture was noted to the walls indicated on the attached
Sketch Plan.
After consideration of the pattern of moisture readings found, and the general pattern
of dampness noted, we conclude that the dampness is due to suspected rainwater
penetration.
OTHER SOURCES OF MOISTURE:
• Contamination of plaster by Hygroscopic Salts.
• The ground level to the adjoining property is set above the internal floor and
damp proof course level. Consequently, lateral penetration, with associated
capillary rise of dampness, is occurring.
Where bridging of any existing damp proof course has been noted, the cause
of the bridging should be rectified. However, where rectification of the
bridging cannot be achieved, or proves to be impracticable for any reason, a
new damp proof course should be inserted into the wall above the upper level
of the bridging, and followed by re-plastering to the relevant section of our
Plastering Specification.
• Defective external rendering.
Current Building Code of Practice states that all render should stop short of
the damp proof course line. The render should be trimmed up and finished in
a bell mouth drip, in accordance with Paragraph 28.6 of BS 5262.
• Condensation caused by a combination of high humidity and cold surfaces.
• The left hand party wall has been dry-lined. This seriously restricted our
inspection.
The true extent of the damp proofing works may be more than can be
currently determined, without removal of sections of the plasterboarding for
further testing, for which we would have to make a charge.
• Rain penetration has occurred, especially to the left hand corner of the
through lounge. If this is allowed to continue, decay is likely to occur in any
timbers that are persistently damp, or wet.
In particular, the lintels, dry-lining fixing timbers and sub-floor timbers are
considered to be highly vulnerable to Fungal Decay.
It was not possible to carry out a detailed inspection of the timbers. We advise that
the Client removes all restrictions, and that a detailed inspection be carried out. We
will, upon written instructions from the Client, return and make a detailed inspection.
GENERALLY:
The above findings are based upon the interpretation of results from a standard non-
destructive inspection; this, by necessity, has limitations. If you require confirmatory/
definitive diagnosis of our findings, then this can be undertaken by the use of
destructive methods of investigation: these will involve some damage and costs to
you.
Fungal Decay is always associated with a high moisture content in timber, and,
therefore, timbers bearing in, or in contact with walls where moisture has, or may
have, penetrated, must be considered suspect.
It is essential that immediate steps be taken to eliminate the source of moisture
ingress identified, and that, thereafter, the building is maintained in a weatherproof
condition.
We have not inspected parts of the property that were covered, unexposed, or
inaccessible at the time of our inspection. We cannot give our assurance that any
such area is free from rising damp.
RECOMMENDATIONS
In order to overcome the problems of apparent Rising Damp / Hygroscopic Salts
referred to above, we have prepared a Specification of Remedial Work. This
Specification includes:-
• The prevention of Rising Damp by the insertion of a DAMP PROOF
COURSE, which
Is odourless and non-flammable, resulting
in minimum discomfort and danger to occupants.
Has the British Board of Agrèment Approval
• The removal and renewal of wall plaster, in strict accordance with the
Company’s PLASTER SPECIFICATION, in order to control future dampness
problems due to Hygroscopic Salts, thus ensuring:-
Minimum delays prior to re-plastering.
Speedy redecoration.