Worktop mitres
Kitchens, doors, rails, stud, tables, chairs, stair cases, garden furniture etc... Find answers and ask questions here!

7 posts   •   Page 1 of 1
billobach181
Ganger
Ganger
Posts: 90
Joined: Sun Mar 04, 2007 11:23 am

Worktop mitres

by billobach181 » Fri Jul 06, 2007 10:51 am

Once the joint has been cut do I use Silicone as a jointing glue or is the other gloues I should use?
Regatss
Bill

will_buckley
Apprentice
Apprentice
Posts: 7
Joined: Tue May 22, 2007 10:02 pm

by will_buckley » Mon Jul 09, 2007 10:00 pm

you fix it with work top clamps underneath and biscuits, the silicone is also a fix but is used more to prevent water from getting in the gap to the ends of the worktop.

billobach181
Ganger
Ganger
Posts: 90
Joined: Sun Mar 04, 2007 11:23 am

worktop mitres

by billobach181 » Wed Jul 11, 2007 9:45 am

Many thans.
Bill

LEO292
Apprentice
Apprentice
Posts: 23
Joined: Thu Jul 12, 2007 9:17 pm

by LEO292 » Thu Jul 12, 2007 11:22 pm

I dont use biscuits on my worktops because you cant lift or drop the worktop when its glued together. Sometimes a final play with the scribe is needed to get them perfectly flush. The bolts are quite enough to hold them together while the silicone(clear, low modulos) cures. Dont screw the worktop down while its still wet untill the next day or the scribe might pull down too! Its happened to me!! as for the colour fill, try to keep away from this unless youve got scratches. Its too expensive and too messy. Hope this helps. Leo

mrfixit
Apprentice
Apprentice
Posts: 7
Joined: Sat Jul 21, 2007 7:30 pm

by mrfixit » Mon Jul 30, 2007 5:56 pm

I always treat any open edges of worktop, around the cut out for the sink easpecially, with a couple of coats of PVA sealer to protect it from any water damage, I then use any proprietary brand of wood glue to fix the two pieces together. The use of the clamps set into the underside of the worktop is in my mind essential but the use of biscuits less so.

susan madley
Labourer
Labourer
Posts: 3
Joined: Mon Jul 30, 2007 10:30 am

Cutting worktop for kitchen sink

by susan madley » Tue Jul 31, 2007 7:17 am

Thanks very much - and fingers crossed!!

tazgully
Labourer
Labourer
Posts: 1
Joined: Mon Aug 06, 2007 11:28 pm

by tazgully » Mon Aug 06, 2007 11:50 pm

Hi,
I always use a waterproof wood glue as I am starting to tighten up the clamps underneath. Also I apply Colorfill to the top of the joint which when clamped up also forms a good waterproof seal. You can buy Colorfill in colours to match the worktop and it helps to disguise the join. Excess can be removed with Colorfill's solvent cleaner.

Steve

7 posts   •   Page 1 of 1
It is currently Sun Nov 10, 2024 9:02 pm