Gas press fit end stop
Information, help and advice on many gas related subjects from gas fires to domestic appliances

2 posts   •   Page 1 of 1
carbar
Apprentice
Apprentice
Posts: 19
Joined: Tue Apr 26, 2011 9:58 am

Gas press fit end stop

by carbar » Mon Sep 10, 2012 2:42 pm

Hi.

I want to replace my gas cooker with an electric one, which would mean cutting the existing gas pipe and fitting a stopend. I was wondering if anyone had any experience with these: http://www.gasproducts.co.uk/acatalog/15mm_Pegler_Yorkshire_Xpress_Copper_Gas_Stop_End.html

Can't find any information on the tool required to install it, but I was wondering if that would be easier than a compression fitting.

Carl

htg engineer
Project Manager
Project Manager
Posts: 3256
Joined: Tue May 22, 2007 6:22 pm

Re: Gas press fit end stop

by htg engineer » Wed Sep 12, 2012 6:48 pm

These fittings are good but the tool to compress them are expensive. You need a Registered gas Installer to cap the gas pip - this isn't a DIY job.

Htg

2 posts   •   Page 1 of 1
It is currently Tue Nov 12, 2024 11:56 pm